©
Dieses Dokument verwendet PHP-Handbuch für chinesische Websites Freigeben
(No version information available, might only be in Git)
ZMQ::SOCKET_PAIR
Exclusive pair pattern
ZMQ::SOCKET_PUB
Publisher socket
ZMQ::SOCKET_SUB
Subscriber socket
ZMQ::SOCKET_REQ
Request socket
ZMQ::SOCKET_REP
Reply socket
ZMQ::SOCKET_XREQ
Alias for SOCKET_DEALER
ZMQ::SOCKET_XREP
Alias for SOCKET_ROUTER
ZMQ::SOCKET_PUSH
Pipeline upstream push socket
ZMQ::SOCKET_PULL
Pipeline downstream pull socket
ZMQ::SOCKET_ROUTER
Extended REP socket that can route replies to requesters
ZMQ::SOCKET_DEALER
Extended REQ socket that load balances to all connected peers
ZMQ::SOCKET_XPUB
Similar to SOCKET_PUB, except you can receive subscriptions as messages. The subscription message is 0 (unsubscribe) or 1 (subscribe) followed by the topic.
ZMQ::SOCKET_XSUB
Similar to SOCKET_SUB, except you can send subscriptions as messages. See SOCKET_XPUB for format.
ZMQ::SOCKET_STREAM
Used to send and receive TCP data from a non-?MQ peer. Available if compiled against ZeroMQ 4.x or higher (Value: integer ).
ZMQ::SOCKOPT_HWM
The high water mark for inbound and outbound messages is a hard limit on the maximum number of outstanding messages ?MQ shall queue in memory for any single peer that the specified socket is communicating with. Setting this option on a socket will only affect connections made after the option has been set. On ZeroMQ 3.x this is a wrapper for setting both SNDHWM and RCVHWM. (Value: integer ).
ZMQ::SOCKOPT_SNDHWM
The ZMQ_SNDHWM option shall set the high water mark for outbound messages on the specified socket. Available if compiled against ZeroMQ 3.x or higher (Value: integer ).
ZMQ::SOCKOPT_RCVHWM
The ZMQ_SNDHWM option shall set the high water mark for inbound messages on the specified socket. Available if compiled against ZeroMQ 3.x or higher (Value: integer ).
ZMQ::SOCKOPT_AFFINITY
Set I/O thread affinity (Value: integer )
ZMQ::SOCKOPT_IDENTITY
Set socket identity (Value: string )
ZMQ::SOCKOPT_SUBSCRIBE
Establish message filter. Valid for subscriber socket (Value: string )
ZMQ::SOCKOPT_UNSUBSCRIBE
Remove message filter. Valid for subscriber socket (Value: string )
ZMQ::SOCKOPT_RATE
Set rate for multicast sockets (pgm) (Value: integer >= 0)
ZMQ::SOCKOPT_RECOVERY_IVL
Set multicast recovery interval (Value: integer >= 0)
ZMQ::SOCKOPT_RECONNECT_IVL
Set the initial reconnection interval (Value: integer >= 0)
ZMQ::SOCKOPT_RECONNECT_IVL_MAX
Set the max reconnection interval (Value: integer >= 0)
ZMQ::SOCKOPT_MCAST_LOOP
Control multicast loopback (Value: integer >= 0)
ZMQ::SOCKOPT_SNDBUF
Set kernel transmit buffer size (Value: integer >= 0)
ZMQ::SOCKOPT_RCVBUF
Set kernel receive buffer size (Value: integer >= 0)
ZMQ::SOCKOPT_RCVMORE
Receive multi-part messages (Value: integer )
ZMQ::SOCKOPT_TYPE
Get the socket type. Valid for getSockOpt (Value: integer )
ZMQ::SOCKOPT_LINGER
The linger value of the socket. Specifies how long the socket blocks trying flush messages after it has been closed (Value: integer )
ZMQ::SOCKOPT_BACKLOG
The SOCKOPT_BACKLOG option shall set the maximum length of the queue of outstanding peer connections for the specified socket; this only applies to connection-oriented transports. (Value: integer )
ZMQ::SOCKOPT_MAXMSGSIZE
Limits the maximum size of the inbound message. Value -1 means no limit. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_SNDTIMEO
Sets the timeout for send operation on the socket. Value -1 means no limit. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_RCVTIMEO
Sets the timeout for receive operation on the socket. Value -1 means no limit. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_IPV4ONLY
Disable IPV6 support if 1. Available if compiled against ZeroMQ 3.x (Value: integer )
ZMQ::SOCKOPT_LAST_ENDPOINT
Retrieve the last connected endpoint - for use with * wildcard ports. Available if compiled against ZeroMQ 3.x or higher (Value: string )
ZMQ::SOCKOPT_TCP_KEEPALIVE_IDLE
Idle time for TCP keepalive. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_TCP_KEEPALIVE_CNT
Count time for TCP keepalive. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_TCP_KEEPALIVE_INTVL
Interval for TCP keepalive. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::SOCKOPT_DELAY_ATTACH_ON_CONNECT
Set a CIDR string to match against incoming TCP connections. Available if compiled against ZeroMQ 3.x or higher (Value: string )
ZMQ::SOCKOPT_TCP_ACCEPT_FILTER
Set a CIDR string to match against incoming TCP connections. Available if compiled against ZeroMQ 3.x or higher (Value: string )
ZMQ::SOCKOPT_XPUB_VERBOSE
Set the XPUB to receive an application message on each instance of a subscription. Available if compiled against ZeroMQ 3.x or higher (Value: string )
ZMQ::SOCKOPT_ROUTER_RAW
Sets the raw mode on the ROUTER, when set to 1. In raw mode when using tcp:// transport the socket will read and write without ZeroMQ framing. Available if compiled against ZeroMQ 4.0 or higher (Value: string )
ZMQ::SOCKOPT_IPV6
Enable IPV6. Available if compiled against ZeroMQ 4.0 or higher (Value: string )
ZMQ::CTXOPT_MAX_SOCKETS
The socket limit for this context. Available if compiled against ZeroMQ 3.x or higher (Value: integer )
ZMQ::POLL_IN
Poll for incoming data
ZMQ::POLL_OUT
Poll for outgoing data
ZMQ::MODE_NOBLOCK
Non-blocking operation. Deprecated, use ZMQ::MODE_DONTWAIT instead
ZMQ::MODE_DONTWAIT
Non-blocking operation
ZMQ::MODE_SNDMORE
Send multi-part message
ZMQ::DEVICE_FORWARDER
Forwarder device
ZMQ::DEVICE_QUEUE
Queue device
ZMQ::DEVICE_STREAMER
Streamer device
ZMQ::ERR_INTERNAL
ZMQ extension internal error
ZMQ::ERR_EAGAIN
Implies that the operation would block when ZMQ::MODE_DONTWAIT is used
ZMQ::ERR_ENOTSUP
The operation is not supported by the socket type
ZMQ::ERR_EFSM
The operation can not be executed because the socket is not in correct state
ZMQ::ERR_ETERM
The context has been terminated