Detailed operation content of Proe using mixed commands to create a frustum model

In Proe modeling, creating a frustum model is a common task, which requires the use of hybrid commands to complete. PHP editor Zimo will explain to you the detailed steps of using mixed commands to create a circular cone model in Proe. Through this article, you will learn how to use Proe's hybrid commands, combined with the circular array and loft commands, to create an accurate and detailed frustum model step by step.

1. Open Proe, create a new solid part, put the software into the three-dimensional modeling state, and perform the operations in the figure below: [Insert-Mix-Extend].

2. The software pops up a [Menu Manager]. After looking at the mixing options, if there is no problem, just click [Finish].

3. A [Extended Item] dialog box appears. The default property in the menu manager is [Straight], so click [Finish].

4. According to the requirements in the menu manager, select the [FRONT] datum plane.

5. See the menu manager and select the default [Forward] for the direction.

6. See the menu manager and click [Default] directly.

7. Enter the sketch interface, click [Circle] on the right toolbar, and draw a circle with a diameter of 100 with the coordinate origin as the center.

8. Here is the key. Look carefully. Press and hold the right button of the mouse until a drop-down menu pops up. Click [Switch Section] in the drop-down menu.

9. Repeat step 7, draw a circle with a diameter of 50 with the coordinate origin as the center, and then click √ in the toolbar on the right to complete and exit the sketch.

10. Set the depth of Section 2 to 50, and then click √.

11. See the [Extended Item] dialog box. The required elements have been set, and you can click [OK].

12. A circular cone with a base diameter of 100, a top diameter of 50, and a height of 50 suddenly appeared. It was just built.

The above is the detailed content of Detailed operation content of Proe using mixed commands to create a frustum model. For more information, please follow other related articles on the PHP Chinese website!