Push the keyhole of the battery to both sides, and then the battery can be removed. Shut down the laptop first. If there are unsaved data, you need to save it first. After shutting down the computer, move it to the back of the laptop, and you can see the location of the battery slot, as shown in the picture below.
First, make sure the computer is turned off and the power adapter is unplugged. Find the battery locking gear on the bottom of the notebook and move it in the direction to unlock it (usually outward). Press and hold the locking gear and gently push the battery to pop it out of the computer.
The specific method is as follows: First remove the computer battery. Then use a screwdriver to pry the battery off from the side. Then use a screwdriver to pry open the battery on the other side. Then slowly pry it open with your hands and a screwdriver. The picture below shows the battery inside after prying it open. If the laptop battery is broken, you can replace it yourself, and the same goes for the circuit board.
Shut down the laptop first, and then disconnect the power cable of the laptop, as shown in the figure below. After shutting down the laptop completely, turn it over to the back of the laptop. The battery of the notebook is at the bottom and is held in place by two buckles.
The method of removing the laptop battery buckle is as follows: Find the location of the battery on the laptop after it is turned off. It is usually located under the keyboard, at the bottom of the computer, or on the side of the computer.
1. Push the keyhole of the battery to both sides, and then the battery can be removed. Shut down the laptop first. If there are unsaved data, you need to save it first. After shutting down the computer, move it to the back of the laptop, and you can see the location of the battery slot, as shown in the picture below.
2. First we need to turn off the power of the computer, and then place the case flat on the table. Use a Phillips screwdriver to open the computer case and set the case aside.
3. The method of removing the laptop battery buckle is as follows: Find the location of the battery on the laptop after it is turned off. It is usually located under the keyboard, at the bottom of the computer, or on the side of the computer.
4. Place the side without the buckle first, then place the battery flat on the slot, press it with the side, and there will be a click. The battery replacement is completed.
5. Laptop batteries can be replaced. There are two types of laptop batteries, one is built-in and non-removable, and the other is external and removable. The former is rarely used and is generally used in ultra-thin notebooks. Most users use it, and it is the battery mode used by most laptops at present.
6. First, you need to turn to the back of the ASUS laptop, and then find the battery buckle on the back. Then use a screwdriver or pen to push the buckle aside to unlock it and release the battery.
Push the keyhole of the battery to both sides, and then the battery can be removed. Shut down the laptop first. If there are unsaved data, you need to save it first. After shutting down the computer, move it to the back of the laptop, and you can see the location of the battery slot, as shown in the picture below.
First, make sure the computer is turned off and the power adapter is unplugged. Find the battery locking gear on the bottom of the notebook and move it in the direction to unlock it (usually outward). Press and hold the locking gear and gently push the battery to pop it out of the computer.
The laptop battery is on the back and is locked by two locks. The battery can be removed by opening the battery lock. First close all programs on the laptop desktop, then shut down the laptop, wait until the computer shuts down and then unplug the laptop.
First we need to turn off the power of the computer and then place the case flat on the table. Use a Phillips screwdriver to open the computer case and set the case aside.
1. First, loosen all the back screws, but be careful not to remove them. Then remove the rear battery first. Then remember to remove the card slot on one side first. You need to push out with a fine needle to remove this card slot. Then started to remove the back cover.
2. Lay the notebook face down and find the battery compartment on the back of the notebook. Find the battery compartment buckles everywhere in the battery compartment. Pull the battery compartment buckle horizontally to the left side, and the battery compartment back panel will open. Take off the back panel of the battery compartment, and you can see a black square battery underneath. Push the battery horizontally to the left, remove the battery, and the operation is completed.
3. You can open the back cover of the Lenovo laptop and you will see the battery inside. There are a few screws next to it. After unscrewing, the battery can be taken out.
4. If disassembly is necessary, you can go to a professional maintenance department for disassembly. Because it is a built-in battery, it does not have a circlip contact method that can be installed and removed at will like an external battery. The built-in battery is plug-in or welded, so special tools are required for removal. The battery on the computer can better protect the power supply and make the power supply more stable.
5. How to disassemble Lenovo v110-14 and add solid state hard drive. Place the notebook backside up on the table and remove the battery. Remove the screws of the back case, hold the back cover with your hand, push it back, and remove the back cover. Remove the original hard drive, bracket on the hard drive, and optical drive.
1. Push the keyhole of the battery to both sides, and then the battery can be removed. Shut down the laptop first. If there are unsaved data, you need to save it first. After shutting down the computer, move it to the back of the laptop, and you can see the location of the battery slot, as shown in the picture below.
2. The laptop battery is on the back and is locked by two locks. Open the battery lock to remove the battery. First close all programs on the laptop desktop, then shut down the laptop, wait until the computer shuts down and then unplug the laptop.
3. You can first remove the laptop battery and then reinstall it. If the problem still cannot be solved, it is recommended to go to the official after-sales service point of the laptop brand to check whether the battery is faulty.
4. Look for the plus sign. Near the "South Bridge" of the motherboard, there is a silver-white disc button battery with a plus sign on the back and a diameter of about two centimeters. 2. Press the latch. Use a flat tool to press the latch on the CMOS battery holder. 3. Take it out by hand. The battery on the motherboard will pop up automatically, and then take it out by hand.
5. Turn the notebook face down, take out the rubber plug, and use a screwdriver to remove the screws. Use tweezers to push the optical drive retaining piece and take out the optical drive. Open all connected cable latches and pull out the cables. Use a screwdriver to remove the screws. Gently lift the back end of the battery and pull out the battery.
The above is the detailed content of Laptop battery removal. For more information, please follow other related articles on the PHP Chinese website!
![[Web front-end] Node.js quick start](https://img.php.cn/upload/course/000/000/067/662b5d34ba7c0227.png)
