Laptop won't turn on after replacing memory stick

Why can’t the notebook be turned on after installing a memory module?

1. The memory module is loose, aging or has quality problems, which will lead to no display failure after power-on. The specific reason is not clear. There is no way to help you determine it when you go to the machine. Other common reasons: the memory is loose or there is a problem with the memory itself. Try re-inserting the memory or replacing the memory.

2. Your situation may be caused by the fact that you did not insert the new memory stick tightly when inserting it. When you insert the memory stick into the slot at an angle, press it in hard, and then press it down again. stuck. You should have no compression issues.

3. It means that the capacity of your memory module is too large, or the memory module is not inserted properly.

After replacing the memory module, the computer cannot be turned on!

1. First, there is a problem with the plug. Second, the memory is incompatible. Third, the memory connection is not good and the contact is poor. .

2. The memory module is not installed properly: Check whether the memory module is firmly inserted into the slot. If it is not installed properly, the computer will not start. It is recommended to disassemble and install again. Incompatible memory module: The specifications of the memory module do not meet the requirements of the computer, such as capacity, frequency, etc., which may cause the computer to fail to boot.

3. Dust problem, remove the dust first, especially the memory slots that have been empty for a long time. There may be dust, resulting in poor contact of the memory modules. Compatibility issues. If the old article can work normally, it means there is no problem.

4. Therefore, it cannot be turned on. If the computer cannot be turned on after adding new memory, the possible problems may be as follows: the memory module interface is not clean, and the dust on the interface needs to be wiped off before reinserting it. The memory module is not inserted in place and the buckles on both sides are not fastened firmly. The specifications of the memory module are wrong, and the main frequency exceeds the requirements of the motherboard. The memory module is broken.

5. Swap the two memory sticks and try again. The only option is to replace the memory. This is the memory alarm sound. If the computer cannot be turned on or lights up, many reasons are hardware problems. If the memory has been touched and there is an alarm sound, it means that the memory is not inserted properly or the memory is damaged or there is a problem with the motherboard memory slot. It is recommended to wipe the memory gold finger clean, reinsert it and turn on the computer.

Why can’t my HP notebook start up after removing the memory module and then installing it? Urgent!!

1. The following are possible reasons: The memory module is not installed properly: If the memory module If it is not plugged in properly or is loose, the computer will not be able to recognize the memory module, causing the system to fail to start or run normally. The memory module is damaged: The memory module may be damaged due to prolonged use or improper use, such as static electricity or wear and tear.

2. If the computer was used normally before but does not turn on after replacing the memory module, it means that the memory module is not in good contact. You can remove the memory module, wipe the golden fingers with an eraser, and clean the memory slot with a waste toothbrush. After that, insert the memory back into the memory slot and try to turn on the computer. In addition, check whether other hardware devices and data cable connections are normal.

3. The graphics card and memory module are incompatible, and the computer does not recognize the new memory module, etc. It is recommended that you reinstall the graphics card driver and BIOS, re-verify whether the memory module is correctly installed and supports the HP Light Shadow Elf 4 system, and clean the memory powder before reinstalling the memory module.

The above is the detailed content of Laptop won't turn on after replacing memory stick. For more information, please follow other related articles on the PHP Chinese website!