©
This document uses PHP Chinese website manual Release
(PHP 4, PHP 5, PHP 7)
imap_mail_copy — Copy specified messages to a mailbox
$imap_stream
, string $msglist
, string $mailbox
[, int $options
= 0
] )
Copies mail messages specified by msglist
to specified mailbox.
imap_stream
由 imap_open() 返回的 IMAP 流。
msglist
msglist
is a range not just message
numbers (as described in » RFC2060).
mailbox
The mailbox name, see imap_open() for more information
options
options
is a bitmask of one or more of
CP_UID
- the sequence numbers contain UIDS
CP_MOVE
- Delete the messages from
the current mailbox after copying
成功时返回 TRUE
, 或者在失败时返回 FALSE
。
[#1] jigar dot dhaduk79 at gmail dot com [2015-09-29 11:11:18]
When we want to copy more than one mail, we can write '(string)' before msg_num. Like..
$msg_num = "1,2,3,4,5,6,7";
$copy = imap_mail_copy($imap_stream, (string) $msg_num, '[Gmail]/Important', CP_UID);
[#2] Ben [2013-01-26 13:18:22]
If you use this function and you get the following notice:
Notice: Unknown: IMAP protocol error: Could not parse command (errflg=2) in Unknown on line 0
Notice: Unknown: Could not parse command (errflg=2) in Unknown on line 0
you should check the function parameters. This notice appears (according to what I found on the internet and my problems) when it gets an invalid $msglist. So be sure to give the right number (as a String!):
"$msg_num", $msg_num or (string) $msg_num.
Dont use '$msg_num' when calling the function, this will literally send the string $msg_num.
You can give a string like "1,3,5,7,8", which will work perfectly fine to move the given mails.
I had all my mailnumbers in an array ( $messageSet) and used
<?php
$messageSetImpl = implode ( "," , $messageSet );
imap_mail_copy( $imapStream, $messageSetImpl, $mailBox )
?>
What I hadn't had thougt of was that my $messageSet was sometimes empty, that was when I got the notice. So you might want to check that by putting first:
<?php
if ( !( empty( $messageSet ) ) ) {
$messageSetImpl = implode ( "," , $messageSet );
imap_mail_copy( $imapStream, $messageSetImpl, $mailBox )
}
?>
That should work.
[#3] richard dot oplustil at gmail dot com [2012-03-26 15:18:41]
imap_ mail_ move and imap_mail_copy don't work with sequence numbers on MS Exchange. imap_ uid in combination with CP_UID works fine.
[#4] marcus at names dot co dot uk [2002-07-08 10:51:40]
If you are having problems getting imap_mail_copy and imap_mail_move to work, check you have installed imap_devel (the imap development libraries) as well as imap (the imap daemon). Without it, PHP appears to configure correctly --with-imap, but some functions do not work.
It took me about 12 hours to figure this out!!
[#5] hxlvt at hotmail dot com [2001-01-04 16:37:35]
After much fooling around, imap_mail_copy did work for me. One thing you might want to check, if you are having problems, is the new mailbox name. Make sure it is just a folder name, e.g. INBOX.haha without the server part.