©
This document uses PHP Chinese website manual Release
(PECL event >= 1.2.6-beta)
Event class represents and event firing on a file descriptor being ready to read from or write to; a file descriptor becoming ready to read from or write to(edge-triggered I/O only); a timeout expiring; a signal occuring; a user-triggered event.
Every event is associated with EventBase . However, event will never fire until it is added (via Event::add() ). An added event remains in pending state until the registered event occurs, thus turning it to active state. To handle events user may register a callback which is called when event becomes active. If event is configured persistent , it remains pending. If it is not persistent, it stops being pending when it's callback runs. Event::del() method deletes event, thus making it non-pending. By means of Event::add() method it could be added again.
$timeout
] )$timeout
] )$timeout
] )$base
, mixed $fd
, int $what
, callable $cb
[, mixed $arg
= NULL
] )$flags
)$base
, mixed $fd
[, int $what
[, callable $cb
[, mixed $arg
]]] )$priority
)$base
, callable $cb
[, mixed $arg
] )$base
, int $signum
, callable $cb
[, mixed $arg
] )$base
, callable $cb
[, mixed $arg
] )Whether event is pending. See About event persistence .
Event::ET
Indicates that the event should be edge-triggered, if the underlying
event base backend supports edge-triggered events. This affects the
semantics of
Event::READ
and
Event::WRITE
.
Event::PERSIST
Indicates that the event is persistent. See About event persistence .
Event::READ
This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.
Event::WRITE
This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.
Event::SIGNAL
Used to implement signal detection. See "Constructing signal events" below.
Event::TIMEOUT
This flag indicates an event that becomes active after a timeout elapses.
The
Event::TIMEOUT
flag is ignored when constructing an event: one can either set a
timeout when event is
added
, or not. It is set in the
$what
argument to the callback function when a timeout has occurred.