WampServer端口的修改
端口被占用了,要怎么讲80改为90?
httpd.conf文件要改那些?
#
# Change this to Listen on specific IP addresses as shown below to
# prevent Apache from glomming onto all bound IP addresses.
#
#Listen 12.34.56.78:80
Listen 0.0.0.0:80
Listen [::0]:80
#
# Dynamic Shared Object (DSO) Support
#
#
# ServerName gives the name and port that the server uses to identify itself.
# This can often be determined automatically, but we recommend you specify
# it explicitly to prevent problems during startup.
#
# If your host doesn't have a registered DNS name, enter its IP address here.
#
ServerName localhost:80
HostnameLookups Off
httpd-ssl.conf文件中
Listen 443
##
## SSL Global Context
##
## All SSL configuration in this context applies both to
## the main server and all SSL-enabled virtual hosts.
##
# General setup for the virtual host
DocumentRoot "c:/Apache24/htdocs"
ServerName www.example.com:443
ServerAdmin [email protected]
ErrorLog "c:/Apache24/logs/error.log"
TransferLog "c:/Apache24/logs/access.log"
# SSL Engine Switch:
# Enable/Disable SSL for this virtual host.
SSLEngine on
------解决思路----------------------
1.在cmd 执行 netstat -o -an >c:\ip.txt
2.去c盘下找到ip.txt，找到端口=80的pid
3.在任务管理器查看pid的进程名称，是否为httpd。
------解决思路----------------------
Listen 0.0.0.0:90
Listen [::0]:90
ServerName localhost:90
